Rockford Fosgate RFK8I 8 AWG Power & Signal Installation Kit
Out of stock
- FULL spec cable ? meets or exceeds AWG (American Wire Gauge) requirements
- 100% Pure Crystal-Oxygen Free Copper (PC-OFC)
- Includes appropriate wire termination hardware
- 8AWG (8.36mm?) 735 strands
$129
Out of stock
Related products
-
Loaded Enclosures, Rockford Fosgate
Rockford Fosgate R2S-1X12 12? Prime R2S Shallow Loaded Enclosure
0 out of 5(0)The R2S-1X12 is a single 12? shallow enclosure with 250 Watts RMS power handling wired to a 2-Ohm load. The enclosure is constructed with 5/8? MDF, covered in high density carpet, and features quick release compression terminals.
- Constructed with 5/8? MDF
- Covered with high density carpet
- High current binding posts
SKU: n/a$260 -
Active Enclosures, Rockford Fosgate
Rockford Fosgate P300-12 Punch Single 12″ 300 Watt Amplified Subwoofer
Active Enclosures, Rockford FosgateRockford Fosgate P300-12 Punch Single 12″ 300 Watt Amplified Subwoofer
0 out of 5(0)The P300-12 powered subwoofer is an ?all-in-one? solution when adding bass to a factory system or just to save space. This model features a 12? subwoofer in a sealed enclosure powered by an internal 300 watt amplifier.
“Closed-loop” design ensures optimum performance between woofer, amplifier and enclosure
Built-in 0?/180? phase switch
Separate low level and speaker level inputs
Built-in adjustable bass boost EQ
Adjustable 12db/Octave low pass crossover
Detachable Power/Ground connector
Intelligent auto turn on/off function
Thermal and over voltage protection
High-efficiency, low current design
Remote bass level control included
Proprietary high output woofer
Constructed with 5/8″ MDF
Large AWG input terminals
Covered with industrial heat activated vinylSKU: n/a$559 -
15", Rockford Fosgate
Rockford Fosgate P1S2 15″ Subwoofer
0 out of 5(0)Rockford Fosgate showcases their fanatical commitment to sonic excellence in the Punch Series of speakers, amps, and subs. If you like to listen to potent, powerful music ? and feel it too ? Punch components will give you impressive sound that’ll stand out in a crowd.
Engineers at Rockford Fosgate designed the P1S2-15 15″ subwoofer to dish out the kind of powerful low end you crave in your ride. Its responsive paper cone is reinforced with the same Kevlar? fibers used in bulletproof vests so you get the best of both worlds ? warm bass that’s exceptionally hard-hitting. Rockford Fosgate uses a new technique to attach the oversized rubber surround to the cone that increases available cone area up to 25%, so this sub can push more air for even bigger bass.
The P1S2-15 sub features an extended pole piece and bumped backplate that leaves more room for heavy excursion, so it’ll hit deeper lows without “bottoming out.” This sub works equally well in a sealed or ported enclosure, so you can choose the kind of bass you want for your system.?The sub’s 2-ohm impedance will draw maximum wattage from your mono sub amp.
To drive this single subwoofer, we recommend a mono amplifier rated between 200 and 375 watts RMS at 2 ohms
Product Highlights:
- 15″ 2-ohm subwoofer
- Kevlar? reinforced paper cone
- nitrile butadiene rubber (NBR) surround
- hybrid StampCast basket provides strength while minimizing weight and resonance
- Vertical Attach Surround Technique (VAST?) increases cone area
- power range: 50-250 watts RMS (500 watts peak power)
- frequency response: 18-250 Hz
- sensitivity: 87 dB
- top-mount depth: 6-5/16″
- sealed box volume: 1.3-3.5 cubic feet
- ported box volume: 2.66 cubic feet
SKU: n/a$249 -
6" x 9", Rockford Fosgate
Rockford Fosgate R169X3 6 x 9″ 3-Way Full-Range Speaker.
0 out of 5(0)The R169X3 is a 6?x9? 3-way full-range speaker rated at 65 watts RMS for a new generation of factory replacement speakers. Kit includes integrated high-pass crossovers and mounting hardware.
- Vacuum Polypropylene cone
- Rubber surround
- Stamped steel basket
- Silk dome pole mounted Piezo tweeter and midrange
- Integrated tweeter crossover
- Grilles and mounting hardware included
SKU: n/a$129 -
12", Rockford Fosgate
Rockford Fosgate P2D4-12″ Subwoofer
0 out of 5(0)his P2 sub features an extended pole piece and bumped backplate that leaves more room for heavy excursion, so it’ll hit deeper lows without “bottoming out.” Special venting keeps the copper-clad aluminum voice coils cool through heavy use for consistent bass performance over time.
The dual 4-ohm voice coils allow you to wire the sub for 2-ohm impedance to work with a mono sub amp, or for 8-ohm impedance if you’re using multiple subs. The P2D4-12 sub works equally well in a sealed or ported enclosure, so you can choose the kind of bass you want for your system.
To drive this single subwoofer, we recommend a mono amplifier rated between 300 and 600 watts RMS at 2 ohms.
Product Highlights:
- 12″ subwoofer with dual 4-ohm voice coils
- Kevlar? reinforced paper cone
- Santoprene surround
- hybrid StampCast basket provides strength while minimizing weight and resonance
- power range: 150-400 watts RMS (800 watts peak power)
- frequency response: 27-250 Hz
- sensitivity: 86 dB
- top-mount depth: 6-3/8″
- sealed box volume: 0.70-1.80 cubic feet
- ported box volume: 1.79 cubic feet
SKU: n/a$299